During our production of induction heating equipment, pay attention to the common problems used in the use of heating equipment, so that the corresponding solution can be found for the problem. GuangYuan · GuangZhiYuan Technology puts forward some suggestions for the use of common problems in the use of heating equipment:
First, when there is a lack of water protection alarm, there may be: water pipes, water pump power or insufficient pressure flow (can not use machine cooling pumps), poor water quality, water path has a clogging phenomenon.
Second, when there is an over-heat protection alarm, there may be: there is too little cooling water, the water flow is insufficient, the water quality is poor, and the water path is blocked.
Third, when an overvoltage protection alarm occurs, the possible reasons are: the grid voltage is too high than the rated voltage is ten percent, and it is used when the power is low.
IV. When there is an overcurrent protection alarm, there may be: the shape size of the self-made inductive ring is incorrect, the workpiece and the induction loop are too small, the workpiece and the sensing ring or the sensing circle itself has a short-circuit fire phenomenon, formulated good induction The impact of the circle is affected by the customer's metal clamp or the effect of adjacent metal objects, etc.
5. When there is a short-phase protection alarm, there may be: three-phase electricity is severely imbalance, three-phase electricity has a lack of one phase, and there is a circuit in the air switch or power supply line.
6. Easy to jump in the work (suddenly stop working), the workpiece into and out the induction circle speed, the workpiece and the sensing ring or the sensing ring itself has a short-circuit fire, the gap between the workpiece and the sensing ring is too small, self-made induction ring The shape size is incorrect.